• Amana refrigerator water filtration cartridge
1 5

Clean n clear Original Fridge Water Filter

$54.00
$54.00 $59.00
Sale Sold out
Shipping calculated at checkout.

Amana Clean n Clear is an original Amana internal refrigerator water filter cartridge. Replaces WF401 and 12527304 fridge filter models

Out of stock

14 Days Return Policy | Free shipping on orders above 65 EUR | Secure payment
View full details

The Clean n clear 12527304 water filter cartridge:

  • is an original internal refrigerator water filter
  • is a replacement cartridge for Amana side-by-side refrigerators with a round, screw-in filter located inside the refrigerator compartment above the top shelf
  • Note: If you have a Kenmore refrigerator and your fridge model number starts with 596, then this cartridge will fit with your refrigerator
  • is tested and Certified by NSF International against NSF/ANSI Standards 42 & 53
  • Amana recommends replacement every 6 months
  • is manufactured by Cuno Inc. for Amana (country of origin U.S.A.)

The Clean n clear fridge filter replaces or is compatible with the following filter part numbers:

Clean n clear
WF401
12527304
WF40
WF30

The Clean n clear water filter reduces the following health related contaminants:

  • 97.66% of Chlorine Taste and Odour
  • 97.88% of Particulates (Class I)
  • 99.37% of Lead at pH 6.5
  • 99.88% of Lead at pH 8.5
  • 91.93% of Lindane
  • 99.99% of Cysts
  • 99.81% of Asbestos
  • 98.58% of Turbidity
  • 84.89% of 2,4-D
  • 76.19% of Atrazine

Tested and Certified by NSF International against NSF/ANSI Standards 42 & 53. As with all built-in refrigerator water filters, the Clean 'n Clear (12527304) does not remove Fluoride.

Note: The filter produces fresher water and ice.

Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. The contaminants or other substances removed or reduced by this water filter are not necessarilly in all user's water.

The Clean n clear (WF401) water filter operating specifications are as follows:

  • Flow Rate
  • Operating Temperature
  • Operating Pressure
  • Technology
  • Function
  • Capacity
  • Service Life
  • Dimensions
1.89 lpm
min 0.5°C / max 38°C
min 244 kPa (35 psi) / max 827 kPa (120 psi)
Carbon Block / Ion exchange
Chemical and Mechanical Reduction
1 135 litres
6 months
approximately 8 cm x 14 cm

Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

Change filter at least every 6 months.

Installation and replacement procedure for the Clean n clear fridge water filter:

  • Turn the old cartridge 90 degrees left (the water will shut off automatically).
  • Gently pull the old water filter down and discard.
  • Remove the protective cover from new filter.
  • Push the new filter up into the position.
  • Turn the filter 90 degrees right.
  • Run water through the dispenser for 1-2 minutes to purge the system.

Reset the water filter status light by pressing and holding the Lock and Water (or Auto light) buttons simultaneously for 4 seconds until the filter status indicator begins to flash, then release the buttons.

When to change a filter: The filter cartridge should be replaced when the replacement indicator light comes on or every 6 months.

Important: It is essential that operation, maintenance and filter replacement be carried out in accordance with manufacture's recommended procedures and guidelines for this product to perform as advertised. Failure to do so may void warranty.

Clean_n_clear User Manual

Recently Viewed Products