Installation and replacement procedure for the GSWF fridge water filter:
Open the cartridge cover by pressing on the tab at the front and pulling down.
Turn the old cartridge left (counter clockwise). Note: A small amount of water may drip down.
Pull the filter out and discard (the water will shut off automatically).
Peel off the protective cover from the new cartridge.
Insert the new cartridge, lining up the arrow on the cartridge with the cartridge holder.
Rotate the filter right (clockwise) until the filter handle is in vertical position. Do not over tighten.
Note: When the cartridge is properly installed, you will fill it "click" as it locks into place.
Close the cartridge cover.
Run water through the dispenser for 3 minutes to purge the system.
Reset the "change filter" indicator light by pressing and holding the Water Filter Reset button for 3 seconds.
When to change a filter: There is a replacement indicator light for the water filter cartridge on the temperature display. The filter cartridge should be replaced when the replacement indicator light turns red, or every 6 months, or if the flow of water to a dispenser or icemaker decreases.
Important: It is essential that operation, maintenance and filter replacement be carried out in accordance with manufacture's recommended procedures and guidelines for this product to perform as advertised. Failure to do so may void warranty.